Press TIMER to display 0, then press ENTER within 6 seconds

‘3

The unit can be turn,ed on at a specified time every day with the built-in timer.

Preparation

Make sLlre the clock is set correctly.

1 Press TIMER to display 0, then press ENTER within 6 seconds.

@is displayed and the hour flashes.

If you press ENTER after 6 seconds, another operation may start.

2Designate the hour of the timer-on time by turning MULTI JOG, then press ENTER.

After you designate the timer-on time, one of the source names flashes on the display.

3 Press one of the function buttons to select a source, then press ENTER.

c If TIUNER/BANID is pressed, the band cannot be selected in this step.

4Select the duration for the timer-activated period with MULTI JOG, then press ENTER.

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

	5 Prepare the source.	u
	To listen to a CD, load the disc to be played first on tray 1.	:
	To listen to a tape, insert the tape into Deck 1 or 2.	:
	To listen to a tape, insert the tape into Deck 1 or 2.	s
	To listen to the radio, tune in to a st;tion.	s
	To listen to the radio, tune in to a st;tion.

6 Press POWER to turn the unit off after adjusting	“~
the volume and tone.	a
the volume and tone.
O remains on the display after the power is turned off (timer	~
standby mode).	e

To listen to the tape, press >.

To record the source, press . on Deck 1.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more.

The timer recording period and tape length

When the length of the tape to be recorded is shorter than the timer recording period, ● on Deck 1 is released before the timer is off.

When the tape length is longer than the timer recording period, ● is not released. If. is not released for a long time, the tape

in the deck may be damaged. Press WA to release	●.	❑
To check the specified time and source		❑
To check the specified time and source

Press TIMER. The timer-on time, the selected source name and the duration for the timer-activated period are displayed for 4

To cancel timer standby mode temporarily

Press TIMER repeatedly until @ disappears on the display.

To restore the timer standby mode, press TIMER once or twice

to display 0,

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

●Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

*44 and> are also available instead of MULTI JOG.

*//SET is also avai/ab/e instead of ENTER

ENGLISH 18