Aiwa Z-VR55 manual Additional Dolby Pro Logic”Modes, Press DOLBY PRO LOGIC

,“

		ADDITIONAL DOLBY PRO LOGIC”MODES
		In addition to the NORMAL mode, this unit is also equipped with
		the PHANTOM and the 3 STEREO modes.
		PHANTOM mode: Use this mode when no center speaker is
		connected. The center channel signals are output through the
		left and right speakers.
		3 STEREO mode: Use this mode when no surround speakers
2	–1	are connected. This mode reproduces rear sounds through the
		front speakers.

To select PHANTOM or 3 STEREO

Press DOLBY PRO LOGIC repeatedly until the desired DOLBY PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode is displayed cyclically as follows.

1 Press the VIDEO/AUX/PHONO and start playback of the video source.

2 Press DOLBY PRO LOGIC.

NORMAL is selected, and the playback sound has the DOLBY PRO LOGIC effect.

To cancel DOLBY PRO LOGIC mode

Press DOLBY PRO LOGIC repeatedly until “P-OFF is displayed.

To change the sound levels during playback

After adjusting the balance with the noise sequencer, the sound levels of the center or surround speakers can be adjusted during riayback of laser discs or video software.

iPress MANUAL SELECT (TEST) on the remote control repeatedly to select “CEN” (center), ‘(S-R” (surround right) or

“S-L”(surround left).
2 While the “CEN”,“S-R or “S-P is displayed, press -	or
* cm the remote control to adjust the volume.

\-- ,

To adjust the balance of connected speaker sound levels

Carry out steps 2 to 4 on page 15.

●Depending on the sound source and/or listening conditions, surround effect may not be obtained even when the DOLBY PRO LOGIC is on.

●The full DOLBY PRO LOGIC effect cannot be obtained when using software without 001- SURWND1 mark.

●The DOLBY PRO LOGIC is automatically canceled when:

-the DSP SURROUND system is turned on.

-the headphones are plugged in.

-the 5.1 CH (page 20) is turned on.

ENGLISH 16