Remove lint panel door, and unscrew the four shipping bolts (one at each corner). Remove tumbler from skid.
NOTE: Do not throw bolts away – they are the leveling legs.Remove four nuts from the literature packet, and screw one fully onto each leveling leg.
Screw the four leveling legs (bolts) back into the level adjusting fittings from the bottom.
Slide tumbler to its permanent location. Adjust the leveling legs until the unit is level within 0.125 inch (3.18 mm). Tumbler must not rock. Lock leveling legs with nuts installed.
NOTE: The front of the tumbler should be slightly higher than the rear (approximately 0.125 inch,
3.18mm). This will prevent the clothes, while tumbling, from wearing on the door glass gasket.
IMPORTANT: Keep tumbler as close to floor as possible. The unit must rest firmly on floor so weight of tumbler is evenly distributed.
Installation
Stacked Tumblers Only:The stacked tumbler (T30) has a fifth leveling leg which is enclosed with this manual. It MUST BE installed on the lower left side of the blower housing to stabilize the tumbler. Refer to Figure 3.
After leveling with the four cabinet leveling legs, install the fifth so that it contacts the floor.
CAUTION
The stacked drying tumbler has a 5th leveling leg on the blower housing. It is very important to properly adjust this leg. Unit is back heavy and could rock or tip.
W250
1
2
1Plastic Cap
2Leveling Leg
T451I
T451I
1 
T467I
T467I
1Fifth Leg
Figure 3
Figure 2
70269701 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 23 |