Installation

Installing Accessory Timing Cam

(Metered Models)

Coin Drop tumblers have eight accessory cams in the literature packet. These allow you to change your vending times. Refer to Table 1. Timer motor RPM is printed on the timer motor.

Cam Pins

1/30 RPM

1/60 RPM

Timer Motor

Timer Motor

 

 

 

 

2

15

30

 

 

 

3

10

20

 

 

 

4

7.5

15

 

 

 

5

6

12

 

 

 

6

5

10

 

 

 

8

3.75

7.5

 

 

 

10

3

6

 

 

 

12

2.5

5

 

 

 

 

Table 1

 

Removal of Existing Timing Cam

1.Rotate cam by hand until “V” notch lines up beneath the ratchet tooth. Refer to Figure 4.

2.Insert narrow screwdriver under nylon cam, close to the clock shaft. Lift gently off shaft. Make sure that pressure is directed upward and that the “V” notch clears the ratchet tooth.

Installation of New Timing Cam

1.Insert drive into timing cam with wide prong in wide hole of cam.

2.Position timing cam and drive fork over the timer shaft, aligning the timer flat with the drive fork and the “V” notch with one of the ratchet teeth.

3.Press timing cam down firmly to seat timing cam onto the motor shaft.

1

2

T039I

1Line up notch to clear ratchet tooth.

2Lift gently with narrow blade.

Figure 4

4.Remove all accumulated time by turning cam counterclockwise until switch shuts off. Apply moderate clockwise pressure to fully seated timing cam and drive against the timing motor shaft. Meter must be advanced electrically for one cycle before an accurate measure of time can be made.

24

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

70269701