Alliance Laundry Systems 70269701R4 3W&G, 2W&G, 3W&G, 3W&G, 1 Phase, 3 Phase, 120 Volt/60 Hertz, 240 Volt/60 Hertz, Conversion Instructions, Connecting Electrical Service

Electrical Requirements

Conversion Instructions

If serial plate voltage is: Tumbler can be converted to the following voltages:

120 Volt/60 Hertz/	208-240 Volt/60 Hertz/1 Phase Models:
1 Phase	3W&G
2W&G	1.	Prior to connecting service, locate the black/red wire which runs between
		terminal block and the motor relay or contactor. Refer to figure below.
						120 V~ LOCATION	208 or 240 V~
						(AS RECEIVED)	LOCATION
							(AS CONVERTED)
						L1	TO MOTOR RELAY
							OR CONTACTOR
					120 V~	N
			208	OR
			240 V~
					120 V~	L3	BLK/RED
						TERMINAL BLOCK		T381I
	2.	Disconnect the black/red lead from L1 of the terminal block and connect to
		L2 of the terminal block. For stacked tumbler complete steps 1 and 2 for
		upper and lower junction box areas.
	3.	Sign and date conversion sticker located on back of tumbler.
	4.	Follow the instructions covered in Connecting Electrical Service section.
240 Volt/60 Hertz/	200-208 Volt/60 Hertz/3 Phase Models:
3 Phase	3W&G
3W&G	1.	Prior to connecting electric service, locate transformer configuration jumper
		in junction box area.
	2.	Remove the 240 Volt jumper and replace it with the 208 Volt jumper located
		in the literature packet in cylinder.
	3.	For stacked tumblers, repeat steps 1 and 2 for each upper and lower unit.
	4.	Sign and date conversion sticker located on back of tumbler.
	5.	Follow the instructions covered in Connecting Electrical Service section.

70269701 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 49