Allied Telesis AT-iMG646PX-ON, AT-EN646 manual Connecting the LAN Cables

AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide

Connecting the LAN Cables

To connect the LAN cables, perform the following procedure:

Note

Allied Telesis recommends that you fully wire all six ports to allow for easy service expansion in the future.

Note

Do not connect the Ethernet cables to the gateway until the unit has completed its bootup sequence. This may take several minutes if network software upgrades are needed.

1.Connect the LAN cables to the RJ-45 ports on the gateway, as shown in Figure 55.

1178

Figure 55. Connecting the LAN Cables

Section II: Indoor Installation 83