AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide

Installing the Grounding Plate

To install the grounding plate, perform the following procedure:

1.Open the outer and inner doors of the enclosure.

2.Remove the grounding plate (shown in Figure 5) and the self-tapping screw from the accessory kit.

Gateway Mounting Post

Ground Wire Post

Aramid Yarn and Tracer Wire Post

 

841

Drop Cable Clamp

Strength Member Clamp

 

Figure 5. Grounding Plate

3.Align the notch in the grounding plate with the vertical support, and the hole in the grounding plate with the hole in the back of the enclosure, as shown in Figure 6.

Mounting Hole

Vertical Support

 

 

842

Figure 6. Aligning the Grounding Plate

4.Use the self-tapping screw to secure the grounding plate to the enclosure through the mounting hole in the grounding plate.

Section I: Outdoor Installation

35

Page 35
Image 35
Allied Telesis AT-iMG646PX-ON, AT-EN646 manual Installing the Grounding Plate