Allied Telesis AT-iMG646PX-ON, AT-EN646 manual 1182

AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide

4.Route the fiber cable 2-1/2 times around the splice tray to the splice organizer and cut it to a length that will allow the splice to be placed in the organizer, as shown in Figure 27.

1182

Figure 27. Setting the Fiber Cable in the Splice Tray

5.Cut the SC/UPC pigtail cable (not provided) 29.25 in. (74.30 cm) beyond the boot.

6.Strip the SC/UPC pigtail jacket to expose 13.75 in. (39.93 cm) of fiber.

7.Clean the fiber, and splice it to the pigtail, per the splice manufacturer’s instructions.

8.Route the pigtail once around the splice tray and out through the upper left corner and secure it with another wire tie, as shown in Figure 28.

1183

Figure 28. Securing the Pigtail

The pigtail should extend 15.5 in. from the splice tray.

9. Trim the wire ties close to the cables.

Section I: Outdoor Installation 49