Chapter 1: Overview

Terminal Port

The terminal port is used to establish a local (out-of-band) management session with the switch. You establish a local management session by connecting a terminal or a personal computer with a terminal emulation program to the port.

The terminal port has an RJ-45 style connector. An RJ-45 to RS-232 management cable is supplied with the switch.

The terminal port is set to the following specifications:

ˆDefault baud rate: 9600 bps (Range is 9600 to 115200 bps)

ˆData bits: 8

ˆParity: None

ˆStop bits: 1

ˆFlow control: None

See Table 16 on page 108 for the pin signal definitions on the RJ-45 port.

Note

These settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulation program.

40

Page 40
Image 40
Allied Telesis x600-48Ts, x600-24Ts/XP, x600-24Ts-POE, X600-24TS-POE+, X600-48TS/XP manual Terminal Port