Allied Telesis x600-24Ts/XP, x600-48Ts, x600-24Ts-POE, X600-24TS-POE+ manual Resetting the Switch

x600 Layer 3 Gigabit Ethernet Switch Installation Guide

Resetting the Switch

You may need to reset the switch after upgrading the firmware or after you have made a configuration change that requires resetting the switch to activate the change.

To reset the x600 switch, perform the following procedure:

1.Locate the RESET button which is on the right hand side of the faceplate.

2.Press the RESET button with the tip of a pen or a similar non-conducting object as shown in Figure 34.

SD					x600-
9					READY	24Ts/XP			Layer	3	Gig
	11											abit E
		13											thernet
			15		BUSY									Switch
				17		FAULT		SFP
					19
						21R	23R	L/A	CONSOLE
													STATUS
								21
10	12	14						22					FAULT
			16					23
				18
					20
						22R							MASTER
							24R	24
													RPS
													PWR		RESET
														1321

Figure 34. Resetting the Switch

73