Allied Telesis X600-48TS/XP, x600-48Ts Installing the Switches in an Equipment Rack, Actactivity

x600 Layer 3 Gigabit Ethernet Switch Installation Guide

Installing the Switches in an Equipment Rack

Perform the following procedure to install each switch in a standard

19-inch rack:

Note

Steps 1, 2, and 3 are optional. These steps provide instructions on how to remove the snap-on plastic feet from the bottom of a switch. You can leave the feet on.

1.Place the switch upside down on a level, secure surface.

2.Using a flat-head screwdriver, remove the snap-on plastic feet from the bottom of the switch, as shown in Figure 31.

Figure 31. Removing the Feet

3.Turn the switch over.

4.Attach a rack-mount bracket to one side of the switch using four of the screws that come with the switch, as shown in Figure 32.

1
3
5
7
	9
	11
	13
	15
2	17
4	19
6	21R
8	23R
	10
	12
	14
	16
	18
	20
	22R	1000	LINK /	PORT
	24R	FDX		ACTACTIVITY
		21		10/100	LINK /
				HDX /		ACT
		22			COL
		23				STACK									x600-
		24								SD							24Ts/XP
		25				1	3	5	7
										9	11								Layer 3	Gigabit
					26							13	15	17	19			SFP			Ethenet Switch
						2										21R		23R	CONSOLE
							4	6	8												STATUS
										10	12	14	16
														18	20						FAULT
																22R 24R					MASTER
																					RPS
																					PWR	RESET
																					1327

Figure 32. Attaching Rack-Mount Brackets

71