Chapter 3: Installing the Hardware
Installing the Power Cord Retaining Clip
Perform the following procedure to install the power cord retaining clip on the switches:
1. Locate the power cord retaining clip, shown in Figure 29.
Figure 29. Power Cord Retaining Clip
2.Install the clip on the AC power connector on the rear panel of the switch. With the “u” of the clip facing down, press the sides of the clip toward the center and insert the short ends into the holes in the retaining bracket, as shown in Figure 30.
100- |
|
240VAC | ~ |
|
Figure 30. Inserting the Retaining Clip into the Retaining Bracket
You are now ready to install the switches in the equipment rack, as explained in the next procedure.
70
