Allied Telesis X600-48TS/XP, x600-48Ts, x600-24Ts/XP, X600-24TS Starting a Local Management Session

Starting a Local

Management

Session

x600 Layer 3 Gigabit Ethernet Switch Installation Guide

3.Connect the other end of the power cord to an appropriate AC power outlet. For power specifications for the switch, refer to “Power Specifications” on page 104.

4.Start a local management session on the unit by performing the next procedure.

The following procedure describes how to connect an RJ-45 cable to an x600 switch. For information about how to log onto the AlliedPlusTM Operating System Software, see the AlliedWare Plus Operating System Software Reference Guide.

To start a local management session on the unit, perform the following procedure:

1.Connect the RJ-45 end of the management cable included with the x600 switch to the Terminal Port on the front panel of the switch, as shown in Figure 48.

SD					x600-
9					READY	24Ts/XP			Layer	3	Gig
	11											abit E
		13											thernet
			15		BUSY									Swi
				17		FAULT		SFP
															tch
					19				CONSOLE
						21R	23R	L/A
													STATUS
								21
10	12	14						22					FAULT
			16					23
				18
					20
						22R							MASTER
							24R	24
													RPS
													PWR		RESET
														1320

Figure 48. Connecting the Management Cable to the RJ-45 Terminal Port

on the Switch

2.Connect the other end of the cable to an RS-232 port on a terminal or a personal computer with a terminal emulation program.

89