Alloy Computer Products POEGEM12T2SFP user manual Subnet Mask

POEGEM12T2SFP User Manual

2.1.3.2. Configuring the POEGEM12T2SFP through the Ethernet Port

There are three different methods of configuring the POEGEM12T2SFP through the Ethernet Port. They are CLI, Web Browser and via SNMP Management Software. We will not cover SNMP management in this manual as it will vary depending on the Network Management Software that is being used.

Note: MIB files can be located for each switch on the CD-ROM, which can then be used with your Network Management Software.

The default IP Address, Subnet Mask and Gateway addresses are shown below: IP Address: 192.168.1.1

Subnet Mask: 255.255.255.0

Gateway: 192.168.1.254

To be able to communicate with the switch via the Ethernet port you will need to ensure that your computer has an IP Address in the same subnet range.

Eg. 192.168.1.5

If using the web management open a web browser and enter the default IP Address of the switch into the address bar.

You will now be prompted to log into the switch, the default username and password is shown below:

Username: admin

Password: admin

Fig. 2-4

Note: The web management configuration will be covered in detail in Chapter 3.

14

Alloy Computer Products Pty Ltd Copyright ©2006