AltiGen comm 600H manual LCD Messages

LCD Messages

AW UNREACHABLE!	Failed to connect to the AltiGen phone server. The user
	is trying to register the IP phone with an invalid IP
	phone’s IP address or the AltiGen Phone Server's IP
	address is invalid.
	Or, the network connection is lost in offhook or connect
	state.
	Refer to “AltiWare is unreachable.” section
	of “The following table provides the most common
	problems an end user may encounter. For Alti-IP 600H
	phone questions or problems not listed here, contact
	AltiGen Technical Support.” on page 41.
Basic-Idle!	IP phone is operating in Basic Mode.
	Execute #27 again to reactivate.
	Check IP Phone Service
	Verify extension is configured for dynamic.
DHCP FAIL!	Although DHCP was enabled, the Alti-IP 600H was not
	able to receive the IP address from the DHCP server.
DUPLICATE IP!	Another device configured with the same IP address as
	the IP phone is detected. The IP Phone cannot function
	correctly until this is corrected.
INVALID IP!	The inputted IP address is invalid.
INPUT AGAIN...
INVALID VAL!	During register of IP extension, an invalid response
	(return value) returned from phone server.
NO IP ADDR!	Alti-IP 600H cannot attach an IP address due to network
	failure.
No Network!	Phone has lost Ethernet connection.
REGISTER FAIL!	Cannot register to the AltiGen phone server.
REGISTER OKAY!	IP extension registered successfully.
REGISTERING!	User entered #27 to manually register the IP extension.
REMOVE OLD EXT.	When #27 is entered, the extension/password
	configuration in the IP Phone is removed.

44Alti-IP 600H Manual