LED 2 light on = network failed

LED 3 light on = DHCP failed

LED 4 light on = attached IP address failed

If the phone successfully passes through these stages, it has started up properly. Otherwise, refer to “Troubleshooting” on page 40.

Active Logon While Another Handset is Already Logged On To the Same Extension

If another analog phone or IP phone is already logged on to the same extension, rebooting the Alti-IP 600H will not register the phone successfully. The user must press #26 on the associated physical phone/IP phone, then on the IP phone, use #27 + ENTER to actively log onto AltiServ. Once the extension is logged on and activated, the calls will then be redirected to this IP Phone.

Important:Also, the user should not use the VM option to logon the Alti-IP 600H.

Restoring Default Settings

To automatically restore the original default settings for the Alti-IP 600H:

1.Press * * 7, then press the ENTER button

2.Press * * 2, then press the ENTER button.

Rebooting the Alti-IP 600H

To reboot the Alti-IP 600H, press * * 3, then press the ENTER button.

Note: When the Alti-IP 600H is rebooted, the AltiWare IP address setting is set back to the original configuration.

Configuring “Phone Setting” Soft Keys

When the soft key is set to “Phone Setting” (in the IP Phone Configuration window of AltiAdmin), the IP Phone user can configure the soft key to store a speed dial number or feature code.

To configure a soft key with phone setting enabled:

Alti-IP 600H Manual 20

Page 30
Image 30
AltiGen comm manual Restoring Default Settings, Rebooting the Alti-IP 600H, Configuring Phone Setting Soft Keys