Alto-Shaam QC-3/QC-20/QC-40/QC-50/QC-50 Remote/QC-100/Qc-100 Remote Danger, Electricalsub Title

I N S TTAILTLLAET I O N

ELECTRICALSUB TITLE

This appliance must be branch circuit protected with proper ampacities, in accordance with the wiring diagram. The Quickchiller must be properly grounded in accordance with the National Electrical Code and applicable local codes. Wire size for the main incoming power to the unit must match the minimum size listed in the specifications applicable to the specific Quickchiller model. For supply connections, locate the wire size listed in this manual.

Before operating the chiller, check all cable connections in the electrical connection area for tightness since connections can loosen during transport.

NOTE: After electrical connections have been completed, operate the appliance in any chilling mode for a period of 15 minutes and recheck the main power connections at the terminal block to make certain they remain tight.

D A N G E R

To avoid electrical shock, this appliance MUST be adequately grounded in accordance with local electrical codes or, in the absence of local codes, with the current edition of the National Electrical Code ANSI/ NFPA No. 70. In Canada, all electrical connections are to be made in accordance with CSA C22.1, Canadian Electrical Code Part 1 or local codes.

DANGER

ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES.

ELECTRICAL SPECIFICATIONS

voltage	phase	cycle/hz	QC-3	QC-20	QC-40	QC-50	QC-100
SELF-CONTAINED
208-240VAC	1 ph	50/60 Hz
Recommended circuit amperage:			20 amps	20 amps	30 amps	40 amps	60 amps
Recommended wire size:			12/2 w.g.	12/2 w.g.	10/2 w.g.	8/2 w.g.	6/2 w.g.­
			n o c o r d a n d p l u g
voltage	phase	cycle/hz	QC-3	QC-20	QC-40	QC-50	QC-100
SELF-CONTAINED
208-240VAC	3 ph	50/60 Hz	not available	not available	not available	20 amps	40 amps
Recommended circuit amperage:
Recommended wire size:						12/3 w.g.	8/3 w.g.
380-415VAC	3 ph	50/60 Hz
Recommended circuit amperage:			not available	not available	30 amps	not available	30 amps
Recommended wire size:					10/2 w.g.		10/2 w.g.
			n o c o r d a n d p l u g
voltage	phase	cycle/hz	QC-3	QC-20	QC-40	QC-50	QC-100
REMOTE COMPRESSOR
(Cabinet Only)
208-240VAC	1 ph	50/60 Hz	not available	not available	not available	20 amps	30 amps
Recommended circuit amperage:						12/2 w.g.	10/2 w.g.
Recommended wire size:
			n o c o r d a n d p l u g

Wire diagrams are located near the top of the unit, close to the compressor or control panel.

QUICKCHILLER • INSTALLATION/OPERATION/SERVICE MANUAL • 1 2 .