AMCC 720-0138-00 manual 002B Verify completed, 002C Source drive ECC error overwritten

Chapter 9. Troubleshooting

by improper shutdown of the unit. This possibility applies to RAID 1, 10, and 5. A rebuild will re-synchronize the unit

When this message is generated, redundant units will be automatically initialized. The initialize will not erase user data, but will recalculate and rewrite user parity data. For more information on the Initialize function, see “About Initialization” on page 69.

002B Verify completed

This message indicates the data integrity verification function (see message “0029 Verify started” on page 123) was completed successfully.

002C Source drive ECC error overwritten

If a read error is encountered during a rebuild and the controller is configured to ‘ignore ECC’ or to ‘Force continue on source errors’, the sector in error is reallocated. You are notified of the event by this message.

002D Source drive error occurred

If an error is encountered during a rebuild operation, this message is generated if the error was on a source drive of the rebuild. Knowing if the error occurred on the source or the destination of the rebuild is useful for troubleshooting.

002E Replacement drive capacity too small

The 3ware RAID controller notifies you by this message when the replacement drive capacity is smaller than required. The replacement drive must be equal to or greater capacity than the drive it is replacing.

002F Verify not started; unit never initialized

This message will be sent by the controller when a verify operation is attempted but the unit has never been initialized before. The unit will transition to initializing mode.

The initialize will not erase user data, but will calculate and write parity data to the drives in the unit. For information on the Initialize function, see “About Initialization” on page 69

0030 Drive not supported

3ware 8000 and 9000 series Serial ATA controllers only support UltraDMA- 100/133 drives when using the parallel to serial ATA converter. This message indicates that an unsupported drive was detected during rollcall or a hot add. This message also could indicate that the Serial to Parallel converter was

124 3ware Serial ATA RAID Controller User Guide for the Power Mac G5