Error and Notification Messages

003D Verify paused

This message will be sent when the verify operation is paused.

Verifies are normally paused for ten minutes after a system first boots up and during non-scheduled times when scheduling is enabled.

003E Migration paused

This message is sent when migration is paused. Migration follows the rebuild schedule. For more information, see “Scheduling Background Tasks” on page 76.

003F Flash file system error detected

The 3ware RAID controller stores some configuration parameters as files in its flash memory. This message will be sent when a corrupted flash file system is found on the controller during boot-up. A further attempt will be made to repair the flash file system. These files usually get corrupted when a flash operation is interrupted by events such as power failures.

0040 Flash file system repaired

This message will be sent if a corrupted flash file system is successfully repaired. Some of the flash files with insufficient data may be lost in the operation. The configuration parameters which are lost will then return to their default values.

0041 Unit number assignments lost

The 3ware RAID controller tries to keep the unit numbers persistent across soft resets. This message will be sent if unit number assignments were lost from some unknown reasons. (This event rarely happens. Please contact AMCC 3ware technical support if this event occurs.)

0042 Primary DCB read error occurred

This message will be sent when the controller finds an error while reading the primary copy of the Disk Configuration Block (DCB). The back-up copy of the DCB will be read if this error occurs. If a valid DCB is found, the primary DCB is re-written to rectify the errors found.

If this error occurs, we recommend verifying the unit. See “Starting a Verify Manually” on page 72.

www.3ware.com

127

Page 135
Image 135
AMCC 720-0138-00 manual 003D Verify paused, 003E Migration paused, 003F Flash file system error detected