B. Ignition Controls
To Remove Hot Surface Ignitor (see burner illustration on page 10)
1. Discontinue power to dryer.
2. Disconnect wire from S1 and GND on the HSI module.
3. Disassemble ignitor from burner by removing the one (1) self tapping screw.
4. Reverse procedure for installation of new ignitor.
To Remove Flame Sensor Probe
1.Discontinue power to dryer.
2.Disconnect the red wire from the flame sensor probe which goes to S2 on the HSI module.
3.Disassemble flame sensor probe from burner by removing the one (1) self tapping screw.
4.Reverse procedure for installation of new flame sensor probe.
HSI Ignitor Flame Sensor Probe
NOTE: Before reestablishing power to dryer visually check the following (see illustration)
A.That the hot surface ignitor wires are connected to S1 and GND on the HSI module.
B.Do not wrap the hot surface ignitor wires and the flame electrode wire together. Improper operation may result. They may run alongside each other.
20
