American Power Conversion VT ISX manual How to install a Battery Module

Configuration – Parts Replacement

To release the battery from the lock mechanism, one person gently pushes the battery upwards again and pulls it out, while the other person supports the battery.

How to install a Battery Module

If additional batteries are needed for extra run-time, or if you install battery replacement modules etc., follow the below procedure:

Wait until you are ready to power up the system before installing Battery Modules in the UPS. Failure to do so can result in a deep discharge of the batteries and cause permanent damage (the time from the battery installation time till the UPS is powered up should

Caution not exceed 72 hours or 3 days).

BATTERY UNIT



BATTERY UNIT



Install the Battery Modules in the lowest available bay.

Position the Battery Unit to slide in between the grooves and push completely into the UPS to ensure connection.

If a problem is reported, ensure that the modules in question are correctly installed. If the problem persists, refer to the Troubleshooting section of this guide.

Allow for a 24-hour recharging period of the batteries after system start-up / battery replacement for battery monitoring data to become fully reliable.

Note

22 Smart-UPS® ISX 30-40 kVA, 400V Operation 990-2820A