Chapter 2 | Installing CoreModule 800 Options |
DDR SODIMM
Press down on SODIMM at both corners until you hear a snap.
Figure 2-4. Pressing down on SODIMM
CM800QkS_11a
10.If the retaining latches do not close completely on the SODIMM, remove it and repeat Steps 7 to 9.
11.Turn the CoreModule 800 back over onto the bottom of the board, placing it on the work surface.
12.Reconnect any cables you disconnected earlier and verify all other connections to the CoreModule 800 are still connected.
13.Reconnect the ATX or AT power supply’s power cord to the AC power source.
14.Restore power to the CoreModule 800 and observe the boot screen for new memory recognition.
If the system does not boot or there is a problem recognizing the new memory, the new SODIMM could be defective or the SODIMM was not properly installed or recognized.
CoreModule 800 | QuickStart Guide | 17 |
