Andrew 9.3-Meter ESA manual Step, Installation Procedures, Use 7/8 by 2-1/4in 57 mm hardware

Step 3

Refer to Figure 21. Apply supplied RTV to flange surface and attach remaining end of 200128 elevation extension assembly to corresponding 201022 pivot assembly as shown.

•Use 7/8 by 2-1/4 in (57 mm) hardware.

For motorized mounts only, remove oil plug on motor assembly gearbox and replace with supplied vent plug packaged with the motor assembly only after elevation jack is in final operating position.

Note: Ensure hole in vent plug is positioned downward.

Figure 21

26 Installation Procedures