Andrew 9.3-Meter ESA manual Step Step, Installation Procedures, Use 7/8 by 2-1/4in 57 mm hardware

Step 7

Step 8

Refer to Figure 16. Attach 200107 support pairs back-to-back with 45967 spacer at mid- point. Loosely attach support pairs to corresponding tabs on 200015/200016 joint assem- blies and 201022 pivot assembly as shown.

•Use 7/8 by 2-1/4 in (57 mm) hardware

Note: Angles are attached edge out with flat of angle facing inward.

301786

Figure 16

Align panning frame/azimuth pivot assembly by swinging panning frame through its entire arc. Slightly snug panning frame/pivot assembly hardware, and again swing panning frame through its entire arc. Continue this procedure until mounting hardware is ready for tensioning.

Note: Do not tighten hardware on 301786/201022 azimuth pivot assemblies at this time.

21 Installation Procedures