Jackscrews/Motors
Gear
Motor/Housing Fill
Drain
Requirements
and remove any old lubricant to prevent an excessive
The following is a list of the lubricant characteristics:
• Mobil Temp SHC32 A
ture range is
•Mobil SHC624 A low temperature synthetic oil for worm gear reducers.
Operating temperature range is
Fahrenheit
• Moly Grease | A grease lubricant containing molybdenum disulfide. Operating |
| temperature range is |
|
Periodically inspect lifting screws on jackscrew assemblies to ensure adequate lubrica- tion. Loosen Jackscrew boot clamps to expose the lifting screw assembly. Fully extend jackscrew assembly being careful not to exceed preset mechanical limits. Brush thin coating of Mobil SHC32 grease on exposed lifting screw. Replace boot and attach corre- sponding boot clamps. If lifting screw is rusty, remove existing lubricant with solvent and wire brush rusted area. Rinse with solvent and apply fresh grease.
Periodically inspect and remove dust or dirt deposits from the motor housings to avoid hindering the heat exchange with the ambient air. Slight dirt accumulation on the air vent screw through splash oil cannot be avoided; however, keep vent screw clean to ensure proper pressure compensation.
Lube points 2, 3, 7 and 8, shown in the Lubrication Chart, require removal of the indicat- ed drain plugs and collecting/measuring the amount of SHC624 drain oil using measur- ing cup. The specified amount of oil must be added to the gear motor/housing (after installing the drain plug) via the fill/vent plug opening using supplied funnel. Addition of the oil requires use of an appropriate filling utensil. Use of a modified level stick will not correctly gauge the appropriate amount of oil in the gear housings.
61 | Preventive Maintenance |