Step 3
Refer to Figure 29. Carefully remove reflector panel segments from packing crates. Begin with center flash panel (if applicable) and attach to corresponding angle tab on upper drum ring as shown.
•Using 5/8 x
drum angle hardware until lock washer is compressed, then back off one half turn. Do not
Note: Use 10 ft temporary support to raise outer portion of reflector segment. Use addi- tional temporary supports as necessary to provide support prior to installation of adja- cent reflector segment panel. Pad top of temporary support to prevent damaging reflec- tor segment panel. Do not step on drum panel inserts.
Figure 29
33 | Installation Procedures |
