Section 4–Device Discovery and Addressing

ATC200-Lite Teletilt® Remote Control Downtilt System

6.The ‘Manual Addressing’ screen will automatically suggest the first avail- able address. The default serial num- ber for a device with an unassigned address is a series of zeros.

If the suggested address is accept- able, click ‘Add Device’ and proceed to Step 8 (Figure 4-11).

If an address different from the one suggested is desired, click on the up/ down arrows next to ‘Device Address’ to specify the new address for the de- vice. Click on the up/down arrows next to ‘Vendor Code’ to select the vendor (AN = Andrew Corporation). Replace the zeros in the serial number field with the serial number of the device (Figure 4-10).

7.Click ‘Add Device’ (Figure 4-11).

8.Click ‘OK’ (Figure 4-12).

2. Select Vendor.

1.To specify a different address, click on the ‘up/down’ arrows.

3.Type in the serial number for the device. Serial numbers are automatically displayed here when a known device address is selected.

Figure 4-10. Assigning a New Address.

Click ‘Add Device’.

Figure 4-11. Adding Device to New Addrewss.

Click ‘OK’.

Figure 4-12. Confirmation of New Device

Address.

4-

May 2005

Bulletin 639510

Page 30
Image 30
Andrew ATC200-Lite manual Assigning a New Address