ATC200-Lite Teletilt® Remote Control Downtilt System

Section 5–Device Configuration

If this occurs, ensure that all cables and connectors to the actuator are properly connected, and that the system is still properly powered up. Also, verify that the actuator is present in the ‘Device Information’ list, and that it does not have a status reading of ‘Not Reporting’. A status of ‘Not Reporting’ indicates that connectivity to the actuator has been lost. After verifying that each of these items are correct, repeat the configuration process.

11.Click ‘OK’ (Figure 5-4) to dismiss the pop-up dialog box. The main screen will display the results of the device configuration.

12.Note that not all of the items that were configured are displayed on the main screen. To verify that each of the items configured were set correctly, select the device in the ‘Device Information’ list and click ‘Edit Selected’ to review each item. Click the ‘Cancel’ button on the ‘Device Configuration’ screen when finished with verification.

Bulletin 639510

May 2005

5-

Page 37
Image 37
Andrew ATC200-Lite manual Bulletin May