2.9 Enclosure

2.9.1 LCD Control Module (LCM)

There are four buttons to control the subsystem LCM (LCD Control Module). These are:

c(Up)

d(Down)

(Enter)

 

(Escape)

 

 

After booting up the system, the following screen shows management port IP and model name:

192.168.10.50 iSCSI-Model-Name

Press , the LCM functions “System Info,”, “Alarm Mute”, “Reset/Shutdown”, “Quick Install”, Volume Wizard”, “View IP Setting”, “Change IP Config” and “Reset to Default” will rotate by pressing c (up) and d (down).

When there is WARNING or ERROR level of event (LCM default filter), the LCM shows the event log to give users more detail from front panel too.

The following table is function description.

System Info

View System information of Firmware Version & RAM Size.

 

 

Alarm Mute

Mute alarm when error occurs.

 

 

Reset/Shutdown

Reset or shutdown controller.

 

 

Quick Install

Quick three steps to create a volume. Please refer to

 

section 3.3 for operation in web UI.

 

 

Volume Wizard

Smart steps to create a volume. Please refer to next

 

chapter for operation in web UI.

 

 

View IP Setting

Display current IP address, subnet mask, and gateway.

 

 

Change IP

Set IP address, subnet mask, and gateway. There are 2

Config

selections, DHCP (Get IP address from DHCP server) or set

 

static IP.

 

 

Reset to Default

Reset to default sets password to default: 00000000, and

 

set IP address to default as DHCP setting.

 

Default IP address: 192.168.10.50 (DHCP)

 

Default subnet mask: 255.255.255.0

 

Default gateway: 192.168.10.254

 

 

[24]

Page 24
Image 24
APC iSCSI SATA II installation and configuration manual Enclosure, LCD Control Module LCM