3.8.2 Upgrade

“Upgrade” can upgrade firmware. Please prepare new firmware file named

“xxxx.bin” in local hard drive, then click “ ” to select the file. Click

”, it will pop up a message “Upgrade system now? If you want to downgrade to the previous FW later (not recommended), please export your system configuration first!”. Click “Cancel” to export system configuration in advance, or click “OK” to start to upgrade firmware.

When upgrading, there is a progress bar running. After finished upgrading, the system must reboot manually to make the new firmware take effect.

3.8.3 Reset to Default

Enter “Reset to default” function, it allows user to reset the controller to the factory default setting.

Reset to default value, the password is: 00000000, and IP address to default DHCP.

Default IP address: 192.168.10.50 (DHCP)

Default subnet mask: 255.255.255.0

Default gateway: 192.168.10.254

[67]

Page 67
Image 67
APC iSCSI SATA II installation and configuration manual Upgrade, Reset to Default