Adjusting the Media Sensor
The
The Gap/Notch sensor is positioned above the media on a movable shaft which can be adjusted out up to 2.5“ (64 mm) from the inside edge of the media. The Reflective sensor is positioned below the media in a position fixed at 6 mm from the inside edge of the media.
Before calibrating the printer for Gap or Notched media, you must adjust the position of the sensor so that it clearly “sees” the gap or notch. The illustration below shows how to adjust the sensor.
Turn the knob Clockwise to move the sensor toward the outside edge
Turn the knob Counterclockwise to move the sensor toward the inside edge
32 |