System Upgrade
Selecting System Upgrade causes the printer to reset itself in preparation for a firmware upgrade. This procedure is performed infrequently, and requires a PC computer and QuickLabel Systems’ upgrade software. If it is necessary to perform a system upgrade, refer to the instructions that are included with the upgrade software.
To initiate a firmware upgrade:
1Press the PRINT/PAUSE key until the printer is in the paused state.
2Press the NEXT or PREVIOUS key until the Sys Upgrade menu is displayed.
Pause: Sys Upgrade
Press SELECT
3Press the SELECT key to confirm that you wish to perform a firmware upgrade. The printer will display the following:
Pause: Sys Upgrade
SELECT to Verify
4Press SELECT again if you are certain you wish to perform a firmware upgrade. The printer will then initiate a power on reset sequence and will display the follow- ing at the end of the sequence.
BEGIN pDATA TRANSFER cycle power to quit
This message indicates that the printer is ready to receive firmware data from the upgrade utility program. During the download process the data LED will flash and the display will show:
DOWNLOAD IN PROGRESS
60 |