3Flip the Drive Roller Lift Lever clockwise to open the drive roller.
4Remove the Media Retainer from the media supply mandrel by first loosening the small nylon retaining screw then sliding the Media Retainer away from the printer and off the mandrel.
5Orient the roll so that the labels are coming off the top and to the right. Using the media retainer to push the roll, slide the roll onto the mandrel until it is firmly seated against the back plate. You will feel resistance as the spring clip on the mandrel secures the roll.
Note
If the media is not fully seated against the back plate, an unprinted vertical area or void will appear on the printed label.
6Ensure that the Media Retainer is firmly against the media roll and hand tighen the nylon retaining screw to secure the Media Retainer to the mandrel.
7Lift the Media Dancer Arm to the right and upwards to relieve backtension on the media supply roll. Unroll approximately a 3 foot length of media.
8Thread the media down and to the left then around the Media Dancer Arm.
9Remove the Media Guide Collar from the lower Media Guide Roller.
10Continue to thread the media over and around the Upper Media Guide Roller then under and around the Lower Media Guide Roller.
30 |