Changing the Fuse or Line Voltage

Your QLS-4100 X has been configured for your line voltage at the factory. Should you need to replace the fuse(s) or reconfigure the printer for a different line volt- age, follow the procedure outlined below.

Tools Needed

Small, flat-blade screwdriver

1Turn the printer off and unplug the AC power cord.

2Insert a small, flat-blade screwdriver into the slot at the top of the AC Power Input.

3Gently twist the screwdriver to pry open the plastic door. The door will swing down when fully opened.

4Insert the screwdriver between the AC Power Input and the red Fuse Holder mod- ule.

5Gently twist the screwdriver until the Fuse Holder begins to slide out. Grasp the Fuse holder and slide it completely out of the AC Power Input.

6Install the appropriate fuse(s) as follows:

110 VAC Operation

1 each - 6.3A fuse

(P/N 24034-002)

 

install the metal shorting clip on fuse holder

220 VAC Operation

2 each - 4.0A fuse

(P/N 24034-004)

remove the metal shorting clip on fuse holder

7Orient the Fuse Holder such that the desired line voltage is near the top of the Fuse Holder.

8Slide the Fuse Holder into the AC Power Input until it is fully seated.

9Swing the plastic door up and push firmly until a snap is heard indicating that the door is fully closed.

10Reconnect the AC Power Cord.

QLS-4100 X

97