Dial Mode | Code: #201 |
|
| Description: Identifies each outside line as either | |
| Valid Entries: | ✓ 1 = |
|
| 2 = Rotary line |
| Considerations: If you are using | |
| need to adjust the Rotary Dialing Timeout (#108). | |
| Programming | Steps: |
1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 2 ] [ 0 ] [ 1 ] . The display reads:
Dial Mode
Line:
2.Enter the first line to be programmed. For example, to program line 8, press [ 8 ] . The display reads:
Dial Mode L8
1 Touch Tone
3. To change the dial mode, press [ Next Data ] . The display reads:
Dial Mode L8
2 Rotary
To program another line, press [Next Item] or [ Prev Item ] until the correct line number shows on the display. Follow step 3 to change the dialing mode. Repeat for all lines that you want to change.
✓ = Factory Setting
To go to the next procedure: [Next Proc ] | To go to a specific procedure: [ # ] [ 2 ] [ 0 ] [ 1 ] . The |
| |
| |||
To go to the previous procedure: [ Prev Proc ] | (where XXX is the procedure number) |
| |
To return data to the factory setting: [ Remove ] | To exit system programming: [Feature ] [ 0 ] [ 0 ] |
| |
|
|
|
|
|
|
|
|
System Programming
