Toll Call Prefix
System Password
Entering the password allows you to override several dialing restric- tions. See appendix B for a sum- mary of dialing restrictions.
Code: #402
Description: Phone companies recognize long distance calls in either of two
ways: a telephone number preceded by 0 or 1 plus an area code or a tele- phone number preceded only by an area code. Use this procedure to tell the PARTNER Plus system which method your phone company uses.
Valid Entries: ✓ 1 = 0 or 1 plus the area code
2 = Area code only (0 or 1 not necessary)
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The display reads:
Toll Call Prefix
1 0/1 + AreaCd
2.To change the toll call prefix, press [ Next Data ] until the appropriate setting appears. For example,
Toll Call Prefix
2 Area Code Only
Code: #403
Description: Identifies the
Valid Entries: Any 4 digits
Considerations: If you assign a password using this procedure, you must enter the password
Programming Steps:
1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The display reads:
Set Password
If a password has previously been set, it will appear on the display.
2.Enter or change the password using the dial pad. For example, to set the password to 5747, press [ 5 ] [ 7 ] [ 4 ] [ 7 ] . The display reads:
Set Password
Data5747
To remove a password, press [ Remove ]
✓ = Factory Setting
To go to the next procedure: [ Next Proc ] |
| Togo to a specific procedure: #[ ] [ x ] [ x ] [ x ] | |
| |||
To go to the previous procedure: [Prev Proc ] |
| (where XXX is the procedure number) | |
|
| ||
To return data to the factory setting: Remove[ | ] | To exit system programming: [Feature ] [ 0 ] [ 0 ] | |
|
|
|
|
System Programming
