AT&T EP5632 user manual Battery

Models: EP5632

1 117
Download 117 pages 42.65 Kb
Page 99
Image 99

Appendix

The battery

Make sure the handset is placed in the charger correctly. The CHARGE

does not charge

 

light on the charger should be on.

in the handset

Remove the battery from the handset and install it in the spare battery

or the handset

 

compartment on the side of the telephone base and let it charge for 16

battery does not

 

hours. Then re-install the charged battery pack into the handset.

accept charge.

If the cordless handset is in the charger or in the telephone base but

 

 

 

the CHARGE light is not on, refer to The charge light is off in the section

 

 

below.

 

It may be necessary to purchase a new battery. Please refer to the

 

 

battery section of this user’s manual.

 

The telephone might be malfunctioning. Please refer to the warranty

 

 

section of this user’s manual for further instruction.

 

 

 

Low Battery is

Place the handset in the base or charger for recharging.

displayed on

Remove and re-install the battery pack and use it normally until fully

screen.

 

discharged, then recharge the handset on the base or charger for 16

hours.

• If the above measures do not correct the problem, the battery pack may need to be replaced.

The telephone does not ring when there is an incoming call.

Make sure the ringer is on. (See page 36 for the handset and page 47 for telephone base ringer volume).

Make sure the telephone line cord and power adapter are plugged in properly (page 9).

The cordless handset may be too far from the telephone base. Move it closer to the telephone base.

There may be too many extension phones on the telephone line to allow all of them to ring simultaneously. Try unplugging some of them.

If the other telephones in your home are having the same problem, the problem is in the wiring or local service. Contact the local telephone company (charges may apply).

Other electronic products can cause interference to your cordless telephone. Try installing your telephone as far away as possible from the following electronic devices: wireless routers, radios, radio towers, pager towers, intercoms, room monitors, televisions, VCRs, personal computers, kitchen appliances, and other cordless telephones.

Test a working telephone at the telephone jack. If another telephone has the same problem, the problem is in the telephone jack. Contact your local telephone company (charges may apply).

The telephone line cord might be malfunctioning. Try installing a new telephone line cord.

Re-install the battery pack and place the cordless handset in the telephone base.

Wait for the cordless handset to synchronize with the telephone base. To be safe, allow up to one minute for this to take place.

95

Page 99
Image 99
AT&T EP5632 user manual Battery