Atari 040-0050-01 manual Set Up the Computer

Section 2 – Cabinet Conversion

Set Up the Computer

The computer comes pre-loaded with the game software. There is no need to reload the software with the CDs in the kit. The Software recovery CDs are included in case you have a software problem in the future or wish to change the specific game titles available.

CAUTION: The computer can be damaged very easily. Use caution when installing the computer. Avoid touching internal components. These components are susceptible to Electrostatic Discharge (ESD) damage.

1.Remove the right side panel from the computer by removing the two screws that hold the panel in place, as shown by the arrows in the picture below. Slide the panel back and then out to remove it from the computer chassis.

2.Place the computer on its side so you can clearly see the inside of the computer. Place the metal computer bracket so that the tab is pointed down, and hook the tab into the bottom mounting hole on the computer, as shown in the picture below.

3.Use the flat-head screw with nylon locking nut to secure the bracket to the top hole of the computer chassis.

4.Repeat steps 2 and 3 for the second mounting bracket.

5.When finished, the two screws with nuts should be closest to the outside edge of the computer chassis, with the bracket tabs hooked into the holes closest to the motherboard, as shown in the last part of the picture above. Re-install the side panel on the computer.

	© 2004 GLOBAL VR®, INC.
040-0050-01 Rev. A 10/29/2004	Page 19 of 48