Atari 040-0050-01 manual Replace the Monitor Optional, Remove the Old Monitor

Section 2 – Cabinet Conversion

Replace the Monitor (Optional)

Note: Do Not use the Universal Video Controller (UVC) board with the Wells Gardner® monitor.

If you have the Monitor Upgrade Kit, perform the steps in this section to remove the old monitor and install the 27-inch Wells-Gardner®monitor.

Remove the Old Monitor

1.Open the service shelf, and remove the glass display shield and monitor bezel.

2.Disconnect ALL wiring from the back of the monitor. Make sure that no wires still connected to the monitor are tied to the cabinet.

3.Remove the four (4) monitor retaining nuts and washers and save them for reinstallation.

4.Remove the monitor from the cabinet. It is advisable to have at least two people to support the weight of the monitor.

5.Proceed to the next section and install the new monitor.

Adapt the Cabinet for the Larger Monitor

If your cabinet already had a 27-inch monitor, you should be able to proceed to the next section and install the monitor.

If your cabinet had a 25-inch monitor, refer to the figure that follows, and perform the following steps to adapt the cabinet hardware for the larger, 27-inch Wells-Gardner®monitor:

1.Note the positioning of the lower monitor bracket to aid in reinstallation. Remove the nuts and bolts that secure the lower monitor bracket to the cabinet. Remove the bracket and save it for reinstallation. Perform the following steps to drill new bolt holes for the bracket to relocate it for the larger monitor.

2.Refer to the figure below and mark straight lines, as shown, through the center of the two sets of bolt holes and about 2" below. Drill two ¼" diameter bolt holes 1-7/16" below the original holes, and along the same centerline. Use the template from the kit (part #:

L-0059) to aid in placing the holes.

3.The overall distance between the bolt heads on the side of the cabinet must be 20-3/4" center-to-center in the long direction, and 1-9/16" center-to-center in the short direction.

gvrSX™ Conversion System Manual
Page 10 of 48	040-0050-01 Rev. A 10/29/2004