Atari 040-0050-01 manual Power on and Test the Cabinet, Run the Joystick Calibration Utility

Section 3 – Power ON and Test the Cabinet

Section 3 – Power ON and Test the Cabinet

Before powering the cabinet ON for the first time, please verify the following:

•AC power is correctly setup inside the cabinet.

•The DC power supply is correctly setup to provide power to the Jamma Conversion Board.

•All connections are correct and secure.

Once you have verified that all hardware is installed correctly, power ON the cabinet and verify that the game starts and runs properly, and that all controls function properly.

Use the Player Control Test (see page 33) from the Operator Menu to verify that the joystick and buttons are working properly.

Insert some coins and verify that the coin inputs are working properly. Start a game (see page 35) and verify that it plays properly.

Run the Joystick Calibration Utility

The Joystick Calibration Utility adjusts the software to match the joystick motion. Run the Joystick Calibration Utility whenever you replace the joystick or install game software on the system.

1.Insert the Joystick Calibration Utility CD in the computer CD-drive. The CD will run automatically. You will see a series of processing screens, followed by windows telling you to move the joystick in certain ways.

2.Move the joystick as instructed by the onscreen prompts.

3.Ignore the windows that refer to "Throttle" and "Rudder." Simply click the trigger to exit from these windows.

gvrSX™ Conversion System Manual
Page 26 of 48	040-0050-01 Rev. A 10/29/2004