Atari 040-0050-01 manual Apply the Cabinet Graphics and Marquee Artwork

Section 2 – Cabinet Conversion

Apply the Cabinet Graphics and Marquee Artwork

GLOBAL VR® requires that all converted cabinets adhere to the strict guidelines for finished cabinet artwork as described in this instruction manual. Perform the following steps to apply the side panel graphics and replace the old marquee artwork.

1.Place a gvrSX™ Logo sticker on each side of the cabinet, centered, level to the ground, at about eye level, as shown in the picture below. After determining placement, peel off the backing and apply the graphic stickers.

2.Remove the screws from the top bracket that holds the marquee glass and artwork to the cabinet, as shown by the arrows in the picture below.

3.Clean both sides of the marquee glass.

4.Insert the new marquee graphic. Center it in the marquee and trim the excess graphic material from the edges as necessary.

5.Re-install the glass and top bracket.

gvrSX™ Conversion System Manual
Page 24 of 48	040-0050-01 Rev. A 10/29/2004