Chapter 8: Installation verification

Faceplate interfaces

The TN8400AP Media Server maintenance complex has the following faceplate interfaces as shown in Figure 5: TN8400AP Media Server faceplate on page 65:

TN8400 Circuit Pack Failure LED - This solid red LED is lit when there is a detected TN8400AP Media Server circuit pack failure.

-Solid red during a turn on sequence and during a reset. When turn on or reset is complete and there are no failures, the LED turns off.

-Solid red indicates that there is a failure on the TN8400AP Media Server circuit pack.

Shutdown button - Hold in the shutdown button for 2 seconds to start a shutdown. The Communication Manager Processor Complex remains in a shutdown state until power is removed and then reapplied. This switch gracefully turns off the operating system and file system so as to not destroy data and require a disk recovery process.

OK to Remove circuit pack LED - This green LED provides a visual status of the shutdown process.

-LED off indicates the system is operational.

-Flashing indicates that the shutdown is in progress.

-Solid indicates It is safe to remove the TN8400AP Media Server circuit pack from the carrier or turn off the carrier where the TN8400AP Media Server circuit pack resides.

Major Alarm Status LED - This red LED indicates that a major alarm condition is detected.

Services Ethernet Link Status LED - This green LED shows the status of the Services Ethernet link. The LED is on when the link is up. The LED flashes any time data transitions are detected.

Services RJ45 connection to the Services laptop - This Ethernet port provides access to a single 10/100 BaseT Ethernet interface by an RJ-45 connector. This port is connected to the Services laptop, and is used for on-site Services access to the system.

Compact Flash in Use LED - This yellow LED indicates that the Compact Flash memory is being accessed.

Compact Flash slot - This slot provides access for storage of translations and selection application data.

USB port for the USB CD-ROM drive - Used to communicate with peripheral equipment such as a USB CD/DVD ROM for software/firmware updates. Do not connect the modem to this port.

Server Active LED - This green LED:

-The LED is on when the Maintenance Processor detects that the primary application of the Communication Manager Processor is loaded and running.

-The LED is off during a power-on reset or when the system is shutting down.

-The LED flashes when a diagnostic /self test is running.

66 Installing and Configuring the Avaya S8400 Media Server

February 2006

Page 66
Image 66
Avaya S8400 manual Faceplate interfaces