Chapter 5: CCM Appliance Commands

69

 

 

 

 

 

Table 5.17: Server PPP Command Parameters (Continued)

 

 

 

 

 

 

 

 

Parameter

Description

 

 

 

 

 

 

 

REMOTEIP=<rem_ip>

IP address to assign to the PPP client end of the PPP connection. Must be on same

 

subnet as LOCALIP address.

 

 

 

 

 

 

 

 

 

 

 

 

MASK=<subnet>

Subnet mask for the PPP dial-in client.

 

 

 

 

 

 

 

Examples

The following command enables the PPP server with a local IP address of 192.168.0.1, a remote IP address of 192.168.0.2 and a subnet mask of 255.255.255.0.

> ser ppp ena loc=192.168.0.1 rem=192.168.0.2 mas=255.255.255.0

The following command enables the PPP server with previously configured IP and subnet mask values. This form of the command would not be valid unless the IP and subnet mask values had been previously configured.

> server ppp enable

Server RADIUS command

The Server RADIUS command defines or deletes RADIUS parameters for the CCM RADIUS client. For more information, see RADIUS authentication on page 30.

When you enter this command, you are prompted to confirm or cancel the specified changes.

NOTE: The IP, Secret and User-Rights parameters are required only when you are first defining RADIUS server values. If you later wish to change other parameters with a subsequent Server RADIUS command, the current IP, Secret, and User-Rights values will be used, unless you change them also.

Access right: SCON

Access level: APPLIANCEADMIN

Syntax

SERVER RADIUS PRIMARYSECONDARY

IP=<radius_ip> SECRET=<secret> USER-RIGHTS=<attr> [AUTHPORT=<udp>] [TIMEOUT=<time-out>] [RETRIES=<retry>] - or -

SERVER RADIUS PRIMARYSECONDARY DELETE

Table 5.18: Server RADIUS Command Parameters

Parameter

Description

 

 

PRIMARY

Indicates either the primary RADIUS server or the secondary RADIUS server is

SECONDARY

being defined or deleted.

 

 

IP=<radius_ip>

IP address of the RADIUS authentication server.