3.In the Select Controller dialog, go to the drop down box near the top and select the PC serial port to which the NextMove ES is connected. If you are unsure which PC serial port is connected to the drive, select Scan all serial ports. If the NextMove ES is connected using USB, it will be scanned automatically.
Click Scan to search for the NextMove ES.
When the search is complete, click ‘NextMove ES’ in the list to select it, and then click Select.
Note: If the NextMove ES is not listed, check the serial or USB cable between the NextMove ES and the PC. Check that the NextMove ES is powered correctly. Click Scan to
4.A dialog box may be displayed to tell you that WorkBench v5 has detected new firmware. Click OK to continue. WorkBench v5 reads back data from the NextMove ES. When this is complete, Edit & Debug mode is displayed. This completes the software installation.
MN1928 | Operation |