Baldor MN1928 Receiving and inspection, Installed in, Introduction, Date, Catalog, Description

2.2 Receiving and inspection

When you receive your NextMove ES, there are several things you should do immediately:

1.Check the condition of the packaging and report any damage immediately to the carrier that delivered your NextMove ES.

2.Remove the NextMove ES from the shipping container but do not remove it from its anti-static bag until you are ready to install it. The packing materials may be retained for future shipment.

3.Verify that the catalog number of the NextMove ES you received is the same as the catalog number listed on your purchase order. The catalog/part number is described in the next section.

4.Inspect the NextMove ES for external damage during shipment and report any damage to the carrier that delivered it.

5.If the NextMove ES is to be stored for several weeks before use, be sure that it is stored in a location that conforms to the storage humidity and temperature specifications shown in section 3.1.1.

2.2.1Identifying the catalog number

NextMove ES cards are available with a number of optional backplane connector cards. As a reminder of which products have been installed, it is a good idea to write the catalog numbers in the space provided below.

NextMove ES catalog number: NES002-501
Backplane catalog number: BPL010-50_______
Installed in: ________________________	Date: ______

A description of the catalog numbers are shown in the following table:

Catalog	Description
number
NES002-501	NextMove ES controller card with USB connection
BPL010-501	Backplane card: Non-isolated
BPL010-502	Backplane card: Opto-isolated with ‘PNP’ (current sourcing) outputs and
	‘active high’ inputs.
BPL010-503	Backplane card: Opto-isolated with ‘NPN’ (current sinking) outputs and
	‘active low’ inputs.

MN1928 Introduction 2-3