
Save Settings When parameter values have been changed they are not permanent until they are saved. If you turn power off
then turn power on, the previous settings (stored in memory) will be used. To make your new parameter
settings the power up settings, they must be saved to non–volatile memory. These new values are always used
until this procedure is used to write new values to non–volatile memory.
Note: Always ensure that “Configure I/O = Disabled” before doing a Parameter Save. If “Configure I/O =
Enabled”, the control cannot run the motor.
Action Description Display Comments
Press Scroll to “SYSTEM” menu. MENU LEVEL
SYSTEM
Press “M” key SYSTEM
CONFIGURE I/O
Press “M” key CONFIGURE I/O
ENABLED
Press or key Select Disabled. CONFIGURE I/O
DISABLED
Press “E” key Exit one level SYSTEM
CONFIGURE I/O
Press “E” key Exit one level MENU LEVEL
SYSTEM
Press Scroll to “PARAMETER SAVE” menu. MENU LEVEL
PARAMETER SAVE
Press “M” key PARAMETER SAVE
UP TO ACTION
Press Press to save parameters. PARAMETER SAVE
REQUESTED
Parameters are saved. Except the
“Local Setpoint”.
Press “E” key Exit one level MENU LEVEL
PARAMETER SAVE
Press “E” several times to return to
the top level.
Note: The Local Setpoint value is not saved as a parameter.
1 SYSTEM
2 CONFIGURE I/O
CONFIGURE ENABLE
1 PARAMETER SAVE
PARAMETER SAVE