Installation Guidelines

Warning on Rotating the Projector

When the lamp casing is installed, it is not allowed to rotate the projector clockwise when facing the lenses. An internal tilt switch will provide to start up the projector.

Correct way of rotating the projector, see image 6a.

Image 6

Image 6a

Safety Area around the Projector

Make sure the projector is located so that the air inlets and outlets for the cooling system are not obstructed. Leave a safety areo of about 1 meter on the left and the right side of the projector.

IR OUT

AIR IN

Safety area for air in & out

Image 7

Installation of the Lamp Casing

Lamp Casing Warnings

Never transport the projector with the lamp casing installed.

The lamp casing should always been transported in a vertical way to avoid damaging the lamp.

Never attempt to disassemble the lamp from its housing or to dispose of it other than by returning it to BARCO. Due to its high internal pressure, the lamp may explode in either hot or cold state.

3-4

 

5976072 BARCO ELM R12 17102000

 

Page 18
Image 18
Barco R9001490 owner manual Safety Area around the Projector