Barco R9001490 What can be connected to these inputs ?, Remark, How to select the RGB input

Connections

RGB Analog Input Module.

What can be connected to these inputs ?

RGB analog input terminals with separate Horizontal and Vertical sync inputs(RGB-HV), with Composite sync input(RGB-S) or with Sync signals on green(RGsB).

Remark

Always use an interface when a computer and local monitor have to be connected to the projector. See 'slot 1' for interfaces to be applied.

R	G	B	H C	V	27910
On
					98

Red

Green

Blue

Vert. sync

Hor. sync or Composite sync

		Green Operation	Diagnostic Code	IR-Receiver
		RedStand- by
Two way	Hardwired
hardwired
remote	remote				OUT	IN
CTRL 3	CTRL 2
		Sync OK IR			On
	Hardwired
	remote	RS232/422 IN	RS232/422 OUT	COMM PORT	TRIGGER OUT
	CTRL 1

G	B	H/ C	V	R	G	B	H / C	V
n				On
HighBandwidth RGB ANALOG INPUT					High Bandwidth 5CABLE INPUT

RGBS/RGsB analog : 5 x BNC Red : 0.7 Vpp ± 3 dB

Blue : 0.7 Vpp ± 3 dB

Green : 0.7 Vpp ± 3 dB

1 Vpp ± 3 dB if sync on green Vert. sync : 1 Vpp to 4 Vpp ± 3 dB Hor. sync / Composite sync :

1 Vpp to 4 Vpp ± 3 dB

9840110	OUT	IN	9840110
	On

R	G	B	H / C	V	9827910
On

All input signals are always 75 ohm terminated, even in the "not selected" mode.

How to select the RGB input :

Key in the corresponding slot number on the RCU or the local keypad.

Sync selection on the Input Slots menu.

The horizontal sync input can be set as separate sync input or as separate sync + video input.

To change this setting :

1Press ADJUST or ENTER key to start up the Adjustment mode.

2 Push the cursor key  or  to select Installation (menu 1)

3Press ENTER.

4Push the cursor key  or  to select Input Slots (menu 2)

5Press ENTER.

6Push the cursor key  or  to select the corresponding RGB Input Slots (menu 3)

7 Press ENTER key to toggle between CV and CS or HS&VS.

5976072 BARCOELM R12 05052000 4-9