Barco R9001490 owner manual Connections Input module insertion into the projector

Connections

Input module insertion into the projector

To insert a module in one of the free slots, handle as follow :

1Power down the projector and disconnect the power cord from the wall outlet.

2Remove the dummy plate covering the chosen input slot by turning out both screws.

3Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.

4Press on both handles of the input module until the module plug seats in the connector of the projector.

5 Secure the input module by tightening both retaining screws.

6 Reconnect the power cord to the wall outlet and switch on the projector.

The new installed module can be selected with the digit buttons on the RCU or the local keypad.

	GreenOperation	Diagnostic Code	IR-Rec eiver
	Red Stand-by
Two way	Hardwired
hardwired
remote	remote
CTRL 3	CTRL 2

Hardwired	Sync OK IR
remote	RS232/422 IN	RS232/422 OUT	COMM PORT	TRIGGER OUT
CTRL 1

On

6',OUT￿',*,7IN$/￿,1387

9840110

On

6',OUT￿',*,7$IN/￿,1387

9840110

R

G

B

H / C

V

R

G

B

H / C

V

6￿9,'(29,(29,'(2￿,1387

R

G

B

H / C

V

27910

On

On

On

98

High Bandwidth RGB ANALOG INPUT

High Bandwidth 5 CABLE INPUT

4-4 5976072 BARCOELM R12 05052000