Getting Started

Lamp Light Output Indication

When starting up and the center lumens measurement is lower than 50 % of its initial value, the lamp light output warning will be displayed for 1 minute. Press ENTER to continue. The message will not be repeated during operation.

WARNING

Lamp run time is 400 hours.

The light output of the lamp is less

than 50% of its initial value.

It is advisable to replace the lamp

before damage occurs.

<ENTER> to confirm

During operation and a start up without any message, the light output message will appear on the screen when the light output is reduced with 33% from its initial value.

This message will be repeated every hour.

Switching to Stand-by.

When the projector is running and you want to go to stand-by, press the stand-by key.

Switching Off

To switch off:

-First press STANDBY key and let the projector cool down until the fans stopblowing, or at least 15 min.

-Switch off the projector with the power switch.

Quick Set Up Adjustments

Quick Language Change

Only if different on screen languages are available, follow the next procedure to change the on screen language.

1Press ENTER to start up the adjustment mode.

2Press the cursor key or to highlight 'Service' (menu 1). When password protected, your password will be asked. (more explanation about access by password can be found in Chapter 'Start up the Adjustment mode'.

3Press ENTER to display the Service mode menu.

3Push the cursor key or to highlight 'Change Language' (menu 2). If not visible in the menu, highlight first 'More' and press ENTER to display a second service menu. Select then 'Change Language'.

4Press ENTER to display the language selection menu.

5Push the cursor key or to highlight the desired language (menu 3). For the moment, only English is available.

ADJUSTMENT MODE

Select a path from below :

RANDOM ACCESS

INSTALLATION

SERVICE

Select with or

then <ENTER> <EXIT> to return.

menu1

SERVICE

IDENTIFICATION

CHANGE PASSWORD CHANGE LANGUAGE CHANGE PROJ. ADDRESS SERIAL COMMUNICATION LAMP

MORE..

Select with or

then <ENTER>

<EXIT> to return.

menu2

CHANGE LANGUAGE

English

Select with or

then <ENTER>

<EXIT> to return.

menu3

5-4

 

5976072 BARCOELM R12 17012000

 

Page 45
Image 45
Barco R9001490 owner manual Getting Started Lamp Light Output Indication, Quick Language Change, Service, Change Language